.416 Rigby N°2 is one of 606 cartridges in the calculator's catalog. Pick a load from your reloading manual, enter it, and the calculator predicts velocity and peak pressure, then gives a verdict against the cartridge's pressure ceiling. It is a comparison tool for working between loads you already trust, not a source of load data.
| Max average pressure (CIP) | 3,250 bar ≈ 47,150 psi |
|---|---|
| Case capacity (water) | 128.1 gr H₂O (8.30 cm³) |
| Case length | 73.7 mm (2.900″) |
| Max overall length | 95.2 mm (3.750″) |
| Bore diameter | 10.570 mm (0.416″) |
| Standard | CIP |
Catalogued reference values the calculator works from. No charge, velocity, or pressure data appears on this page; loads come from your manual. The calculator's percent-of-limit verdict is judged against the SAAMI maximum pressure for this cartridge where one exists, which can differ from the CIP figure shown here.
.416 Rigby N°2 is fully supported in the calculator, but the current published validation corpus has no .416 Rigby N°2 loads in it yet, so IBC prints no per-cartridge accuracy figure here. Per-cartridge numbers on this site appear only where the corpus actually contains loads for that cartridge. The corpus-wide results and the method behind them are on the methodology page.
Open the calculator, pick .416 Rigby N°2 from the cartridge list, and enter a load from your current reloading manual. Compare variants: bullet weights, powders, charge steps. Start 10% below the manual's maximum charge and work up, watch the verdict on every rung, and check real pressure signs at the bench. The free tier covers single-load predictions; PRO unlocks the full work-up ladder and the charts.
Open the calculatorAccuracy figures on this page were computed from the published-manual validation corpus (9796 loads across 155 cartridges) with engine v1.1.14 (corpus build da7ac091). Page generated 2026-11-15. Method and provenance: methodology & accuracy.